Lineman Pliers

tungsten carbide jaws, double-action, maximum capacity 3?32" (2.5mm), 8-1/2" (21.6 cm) End Cutter is a unique instrument designed for cutting of surgical pins or wire. Many orthopedic and neurosurgical spinal procedures require the use of such stabilization accessories to prevent trauma during recovery and confer additionally stability. This instrument is particularly well suited for end cutting which allows it to be made flush with the edge of bone or other tissue ares where it is being used. Additionally this end cutter is double-action and features tungsten carbide jaws with a maximum capacity of 3/32".

cuts up to 5/64" (2.0 mm) diameter hard wire, 6-1/2" (16.5 cm) Diamond Pin Wire Cutter is a specially designed instrument crafted for use in cutting wire. Many different neurosurgical and orthopedic procedures require the insertion of wire to give the areas additional stability and this cutter can be used to clip these at the desired length. Not only can this instrument be used to trim wire but also surgical pins. Fracture repair and other bone repair surgeries has to be set with pins that also need to be trimmed using this instrument. This instrument is available in two designs: stainless steal or tungsten carbide both of which can cup up to a diameter of 2.0 mm.

tungsten carbide jaws, cuts up to 0.047" (1.1 mm) diameter hard wire, 6" (15.2 cm) K-Wire Side Cutter is a versatile instrument that can be used in a variety of surgical procedures. It is specifically designed for use in cutting wire in a particular perpendicular orientation. The unique design of this instrument allows it to comfortably be set flush against the areas where the wire has been inserted and clip it at a length that makes it the best fit. A variety of spinal procedures require for the placement of wire through the newly grafted area to give additional support throughout recovery and this instrument can be used in manipulation and cutting of these wires. Additionally this instrument features tungsten carbide jaws and can cut wires up to a diameter of 1.1 mm.

serrated jaws, 5-1/2" (14.0 cm) Flat Nose Pliers are ideally suited for use in manipulation of wire. Particularly these pliers can be used in situations where it is required to make very sharp, angled bends in the wire. The wider tip makes this instrument ideal for grasping Steinmann pins and K-wires. Additionally this instrument measure 5.5" long and is forged from premium German grade steel making it a finely crafted and reliable instrument.